News

  • 2015-02-20 10:20:56
    In the production and application process, pultrusion mould may failure often in various different situations, that will waste a lot of labor cost, material resources, and affect the production schedule. Several of the main mould basic failure modes a……[more]
  • 2015-02-19 12:54:20
    FRP pultruded profiles has good surface properties: when composite materials mix with chemical medium products, surface generally has little corrosion product, rarely fouling. The pipe line resistance is very small, low friction coefficient and that w……[more]
  • 2015-02-18 10:09:03
    Hydraulic FRP pultrusion production line adopts hydraulic advanced control system to realize the reciprocating traction, automatic cutting, high production efficiency.Traction speed, adjustable pressure, temperature control with high precis……[more]
  • 2015-02-17 09:20:14
    Continuous Resin Transfer Molding Pultrusion Process is developed in late of 1970. Glass fiber goes through yarn guide and pre forming system into a continuous resin transfer mould to stabilize the pressure and flow rate, injection of special resin, g……[more]
  • 2015-02-16 09:20:20
    Fiberglass Pultruded Gratings: Fiberglass pultruded gratings use pultrusion mould "I" and "T" shaped profile as the bearing, with a solid bar or pipe as the connection rod, and it is made by a certain assembly processwith gap plate. Pultruded grati……[more]
  • 2015-02-15 09:21:23
    FRP pultrusion process raw materials and auxiliary materials include glass fiber reinforced resin matrix material and auxiliary materials. Glass fiber reinforced materials include roving,continuous filament mat etc. Reinforced material support frame o……[more]
  • 2015-02-14 06:47:29
    Fiberglass continuous winding pipe technology a new pipe production technology at present in our country, the study direction of this process is mainly development of the large and high pressure pipe. The fiberglass pipe is one of the most rapid produ……[more]
  • 2015-02-13 10:43:55
    FRP profiles pultrusion process and control parameters There are totally eight steps in FRP pultrusion molding process,: spinning and twisting, prepreg,heating, and the size of the calibration measurement of solidification, cooling, drawing and cut……[more]
  • 2015-02-12 10:37:32
    Insulated Fiberglass Sheet Production Process Introduction: Cutting, laminated, put them into the mould, hot pressing, cooling, demoulding, after treatment,inspection and finished product……[more]
  • 2015-02-11 08:50:01
    Fiberglass gratings used for washing room is very common, there are several reasons: 1. The car wash roon fiberglass pultruded and molded gratings have high strength, corrosion resistance, aging resistance, long service life, about 40-50 years. The w……[more]